Artesyn ATCA-7368 Installation and Use (June 2014) User Manual
Page 55
Hardware Preparation and Installation
ATCA-7368 Installation and Use (6806800M12D)
55
5. Fully insert the blade and lock it to the shelf by squeezing the lever and the latch
together and turning the handles towards the faceplate.
If your shelf is powered on, as soon as the blade is connected to the backplane
power pins, the blue LED is illuminated.
When the blade is completely installed, the blue LED starts to blink. This indicates
that the blade announces its presence to the shelf management controller.
6. Wait until the blue LED is switched off, then tighten the faceplate screws which
secure the blade to the shelf.
The switched off blue LED indicates that the blade’s payload has been powered up
and that the blade is active.
7. Connect cables to the faceplate, if applicable.
If an RTM is connected to the front blade, make sure that the handles of both the RTM and
the front blade are closed in order to power up the blade’s payload.