Artesyn ATCA-7368 Installation and Use (June 2014) - Manual (Page 107)

Supported IPMI Commands
ATCA-7368 Installation and Use (6806800M12D) 107
7.2.7 Chassis Device Commands
7.2.7.1 System Boot Options Commands
The IPMI system boot options commands allow you to control the boot process of a blade by
sending boot parameters to the blade’s boot firmware (for example BIOS, U-Boot or VxWorks).
The boot firmware interprets the sent boot parameters and executes the boot process
accordingly. Each boot parameter addresses a particular functionality and consists of a
sequence of one or more bytes. The IPMI specification assigns numbers to boot parameters.
Boot parameters 0 to 7 are standard parameters whose structure and functionality is defined
by the IPMI specification. The boot parameters 96 to 127 are OEM-specific which can be used
for different purposes.
When using the Get/Set System Boot Options commands, except for parameter 100, use the
response/request data fields with the Set Selector and the Block Selector set to 0x00. When
using the Get/Set System Boot Option for the parameter 100, the Set Selector and the Block
Selector have a specific meaning. Details are given in
System Boot Options Parameter #100 on
page 110 for details.
Get Sensor Reading 0x04/0x05 0x2D -
Get Sensor Type 0x04/0x05 0x2F -
Set Event Receiver 0x04/0x05 0x00 -
Get Event Receiver 0x04/0x05 0x01 -
Platform Event 0x04/0x05 0x02 -
Table 7-6 Supported Sensor Device Commands (continued)
Command
NetFn
(Request/Response) CMD
Comments
Table 7-7 Supported Chassis Device Commands
Command NetFn (Request/Response) CMD
Set System Boot Options 0x00/0x01 0x08
Get System Boot Options 0x00/0x01 0x09