Artesyn ATCA-7368 Installation and Use (June 2014) - Manual (Page 121)

Supported IPMI Commands
ATCA-7368 Installation and Use (6806800M12D) 121
7.4 Artesyn Specific Commands
The Artesyn IPMC supports several commands which are not defined in the IPMI or PICMG 3.0
specification but are introduced by Artesyn Embedded Technologies: serial output commands.
7.4.1 Set/Get Feature Configuration
This command can be used to enable/disable features within the IPMC during runtime.
 Before sending any of these commands, the shelf management software must check
whether the receiving IPMI controller supports Artesyn specific IPMI commands by using
the IPMI command 'Get Device ID'. Sending Artesyn specific commands to IPMI
controllers which do not support these IPMI commands will lead to no or undefined
results.
 Proper handling of these commands is required to write a portable application.
Table 7-19 Set/Get Feature Configuration
Command Name
NetFn
(Request/Response)
CMD Description
Set Feature Configuration 0x2E/0x2F 0x1E
Get Feature Configuration 0x2E/0x2F 0x1F