3 usb 2.0 flash module – Artesyn ATCA-7368 Installation and Use (June 2014) User Manual
Page 51

Hardware Preparation and Installation
ATCA-7368 Installation and Use (6806800M12D)
51
Removal Procedure
To remove a PMEM/SATA module, proceed as follows:
1. Remove the blade from the system as described in
Installing and Removing the Blade
.
2. Remove the two screws holding the
PMEM/SATA module
.
3. Remove the
PMEM/SATA module
from the blade.
4. Reinstall the blade into the system as described in
Installing and Removing the Blade
.
2.5.3
USB 2.0 Flash Module
The blades provides a USB 2.0 flash module with a capacity of 4 GB or 16 GB. The corresponding
removal/installation procedures are described in this section.
The location of the USB 2.0 Flash Module is shown in
Figure "Blade Layout" on page 46
.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.