Controls, indicators, and connectors, 1 overview, 2 faceplate – Artesyn ATCA-7368 Installation and Use (June 2014) User Manual
Page 59: 1 leds and interfaces, 1 overview 3.2 faceplate, Figure 3-1, Faceplate, Chapter 3, Leds and interfaces

Chapter 3
ATCA-7368 Installation and Use (6806800M12D)
59
Controls, Indicators, and Connectors
3.1
Overview
This chapter describes the LEDs, connectors, and external interfaces of the board.
3.2
Faceplate
The following figure shows the connectors, keys, and LEDs available at the Faceplate.
The blade design provides the possibility to cover unused Faceplate elements like LEDs or push
buttons behind a custom overlay foil. The following figure gives an overview of the ATCA-7368
faceplate features.
3.2.1
LEDs and Interfaces
The blade's faceplate provides the following interfaces and control elements:
Two USB 2.0 ports
Serial console port to connect to either payload or IPMC serial I/F
Out of Service, In Service, Attention, and Hot Swap LEDs (IPMC control)
Figure 3-1
Faceplate