beautypg.com

7 persistent memory module (pmem), 8 ethernet ports, Figure 5-4 – Artesyn ATCA-7368 Installation and Use (June 2014) User Manual

Page 90: Sfmem-7221 module dimensions (bottom view)

background image

Functional Description

ATCA-7368 Installation and Use (6806800M12D)

90

5.7

Persistent Memory Module (PMEM)

The ATCA-7368 provides a connector to assemble the Artesyn 7221-SFMEM (P/N #122265)
module, a 48x37 low profile module integrating a PLX9030 PCI target-only Bridge and 64 Mb
of Flash and 16 Mb of SRAM. The module connector is a 80-pin low density, low profile Molex
Connector and features four configuration signals connected to the Glue Logic FPGA. Host and
IPMC can configure the memory module through the configuration pins to use the FLASH as
two 32 Mb mirrored banks (switchable, only one visible) or as continuous 64 MB Flash bank.
Additionally, each bank is write protect able.

5.8

Ethernet Ports

The blade utilizes various Ethernet controllers that serve the ATCA Base I/F, Fabric I/F, Update
Channel and Ethernet console. All Ethernet interfaces have 1GbE capability except for the
Fabric I/F controller which can operate at 10 GbE or 1 GbE (PICMG 3.1 Option 9 and 1). The
fabric I/F is fully operable in both 10G and 1G mode without the presence of an RTM.

Two Ethernet ports are available on the front panel. Additional Ethernet ports for external
access are provided via the RTM.

Figure 5-4

SFMEM-7221 Module dimensions (bottom view)

This manual is related to the following products: