Dell PowerConnect M6220 - Manual (Page 513)

Configuring Routing 511
• Receive Version — Specifies which RIP version control packets are accepted by the interface. The
default is Both. Possible values are:
–
RIP-1 — only RIP version 1 formatted packets are received.
– RIP-2 — only RIP version 2 formatted packets are received.
– Both — packets are received in either format.
– None — no RIP control packets are received.
• RIP Admin Mode — Specifies whether RIP is Enabled or Disabled on the interface.
• Link State — Specifies whether the RIP interface is up or down.
Displaying RIP Interface Summary using the CLI Command
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• Routing Information Protocol (RIP) Commands