Dell PowerConnect M6220 User Manual
Page 505
Configuring Routing
503
• Server Address — The IPv4 address of the server to which packets are relayed for the specific UDP
Destination Port.
• Hit Count — The number of times a packet has been forwarded or discarded according to this entry.
•
Remove — Removes the specified UDP Relay when selected and Apply Changes is pressed.
Adding an IP Helper Entry
1. Open the IP Helper Global Configuration page
.
2. Click Add to display the Add Helper IP Address page:
Figure 9-24. Add Helper IP Address
3. Select a UDP Destination port name from the menu or enter the UDP Destination Port ID. Select the
Default Set to configure for the relay entry for the default set of protocols.
NOTE: If the DefaultSet option is specified, the device by default forwards UDP Broadcast packets for the
following services: IEN-116 Name Service (port 42), DNS (port 53), NetBIOS Name Server (port 137), NetBIOS
Datagram Server (port 138), TACACS Server (Port 49), and Time Service (port 37).
4. Enter the IP address of the server to which the packets with the given UDP Destination Port will be
relayed.
5. Click Apply Changes.
The UDP/Helper Relay is added and the device is updated.