Dell PowerConnect M6220 - Manual (Page 712)

710 Configuring IP Multicast
Adding a Static RP
Use the Add Static RP page to add the specified static rendezvous point (RP) for the PIM router.
1. Open the Static RP Configuration page.
2. Click Add.
The Add Static RP page displays.
Figure 12-41. Add Static RP
3. Enter the IP address of the RP for the group range.
4. Enter the group address of the RP.
5. Enter the group mask of the RP.
6. Check the Override option to configure the static RP to override the dynamic (candidate) RPs learned
for same group ranges.
7. Click Apply Changes.
The new Static RP is added, and the device is updated.