Dell PowerConnect M6220 - Manual (Page 349)

Configuring Switching Information 347
Configuring Voice VLAN Settings
1. Open the Voice VLAN Configuration page.
2. Configure the settings for the system or for each port.
3. Click Apply Changes.
The system parameters are applied, and the device is updated.
Configuring Voice VLAN Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
Voice VLAN Commands
Aggregating Ports
Link Aggregation allows one or more full duplex (FDX) Ethernet links to be aggregated together to form
a Link Aggregation Group (LAG). This allows the networking switch to treat the LAG as if it is a single
link.
Static LAGs are supported. When a port is added to a LAG as a static member, it neither transmits nor
receives LACPDUs.
To display the Link Aggregation menu page, click Switching > Link Aggregation in the tree view. The
Link Aggregation page contains links to the following features:
• LACP Parameters
• LAG Membership
• LAG Hash Configuration
• LAG Hash Summary
LACP Parameters
Link Aggregation is initiated and maintained by the periodic exchanges of LACPDUs. Use the LACP
Parameters page to configure LACP LAGs.
To display the LACP Parameters page, click Switching > Link Aggregation > LACP Parameters in the
tree view.