Dell PowerConnect M6220 - Manual (Page 589)

Configuring IPv6 587
• Default Route Advertise: Use this section to configure the parameters for Default Route
Advertisements into OSPF domain.
• Default Information Originate — Enable or disable Default Route Advertise.
NOTE: The values for Always, Metric, and Metric Type can only be configured after Default Information Originate is
set to Enable.
If Default Information Originate is set to Enable and values for Always, Metric, and Metric Type are
already configured, then setting Default Information Originate back to disable sets the Always, Metric,
and Metric Type values to default.
• Always — Sets the router advertise ::/0 when set to True.
• Metric — Specifies the metric of the default route. Valid values are 0 to 16777214.
Metric Type — Sets the metric type of the default route. Valid values are External Type 1 and External
Type 2.
Configuring OSPFv3
1. Open the OSPFv3 Configuration page.
2. Modify the fields as needed.
3. Click Apply Changes.
The OSPFv3 configuration is saved, and the device is updated.
Configuring OSPFv3 using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• OSPFv3 Commands