Dell PowerConnect M6220 - Manual (Page 88)

86 Configuring Dell PowerConnect
TFTP Filename.................................. PC8024v3.1.0.x.stk
Data Type...................................... Code
Destination Filename........................... image
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
5. Select the image for the next boot by entering the boot system command. After this command,
enter the command show version to verify that the copy indicated as a parameter in the boot
system
command is selected for the next boot.
The following is an example of the information that appears:
console#boot system image2
Activating image image2 ..
console>show version
Image Descriptions
image1 : default image
image2 :
Images currently available on Flash
--------------------------------------------------------------
unit image1 image2 current-activenext-active
--------------------------------------------------------------
1 3.1.0.0 3.1.0.1 image1 image2
If the image for the next boot is not selected by entering the boot system command, the system
boots from the currently active image (image1, as given in the example).
6. Enter the command reload. The following message displays:
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n)
7. Enter y. The following message then displays.
Configuration Not Saved!
Are you sure you want to reload the stack? (y/n)
8. Enter y to reboot the switch.