Dell PowerConnect M6220 - Manual (Page 557)

Configuring Routing 555
Removing a Loopback
1. Open the Loopback Configuration page.
2. Specify the loopback to remove in the Loopback drop-down menu.
3. Click Delete Loopback.
The loopback is deleted, and the device is updated.
Removing a Secondary Address
1. Open the Loopback Configuration page.
2. Specify the loopback to be affected.
3. Specify the secondary address to be removed.
4. Click Delete Selected Secondary.
The secondary address is deleted, and the device is updated.
Configuring a Loopback using CLI Commands
For information about the CLI commands that perform this function, see the following chapters in the
CLI Reference Guide:
• Loopback Interface Commands
• IP Addressing Commands
• IPv6 Routing Commands