Initial connection – Dell PowerConnect M6220 User Manual

Page 96

Configuring Dell PowerConnect

Initial Connection

1. Using the RS-232 port, connect the switch to the workstation.
2. Set the ASCII terminal with the following settings and select the appropriate COM port.

The sample screen uses the HyperTerminal.

Figure 5-3. HyperTerminal Properties Window

Note: 9600 is the default baud rate for a new switch. The switch may have another baud rate. If using the

default baud rate does not result in viewing the switch terminal, try another baud rate.

3. Use the provided serial cable to connect the workstation to the switch.
4. Connect the switch power cord and power up the switch. The system begins the boot process. When

the following displays, you can enter the

Boot menu by selecting 2, if necessary, to run special

procedures.

Select an option. If no selection in 10 seconds then operational code

will start.

1 - Start operational code.

2 - Start Boot Menu.

Select (1, 2):2

This manual is related to the following products:

PowerConnect M6348