Dell PowerConnect M6220 - Manual (Page 342)

340 Configuring Switching Information
Figure 7-62. Protocol Group
The Protocol Group page contains the following fields:
• Protocol Group — Displays the name associated with the protocol group ID (up to 16 characters).
Create a new group by clicking the Add button.
• Protocol — Specifies protocols (in hexadecimal format in the range 0x0600 to 0xffff) associated with
this group. Enter up to 16 protocols using comma separated list.
• VLAN ID (1–4093) — Specifies VLAN ID associated with this group.
• Interface — Selects the interface(s) to add or remove from this group. Highlight the interfaces to be in
the protocol group and click the right arrow. Interfaces displayed in right-hand column are part of the
protocol group.
• Remove Protocol Group — Removes the protocol group displayed on screen when checked and Apply
Changes is clicked. To remove multiple groups at the same time, click Show All and use the Remove
check boxes on the Protocol Group Table.
Adding a Protocol Group
1. Open the Protocol Group page.
2. Click Add.
The Add Protocol Group page displays.