Dell PowerConnect M6220 - Manual (Page 708)

706 Configuring IP Multicast
The PIM Interface Summary page contains the following fields:
• Interface — Select the interface for which data is to be displayed. There must be configured at least
one router interface before displaying data for a PIM interface, otherwise an error message displays.
Interface Parameters fields are:
• Admin Mode — Displays the administrative status of PIM for the selected interface.
• Protocol State — The operational state of the PIM protocol on this interface.
•
IP Address — The IP address of the selected interface.
• Hello Interval — The frequency (in seconds) at which PIM hello messages are transmitted on the
selected interface.
• Join/Prune Interval — The frequency (in seconds) at which PIM Join/Prune messages are transmitted
on this PIM interface.
• DR Priority — Indicates the DR priority on the PIM interface. This field is supported in PIM-SM only.
• BSR Border — Specifies the BSR border mode on the PIM interface. This field is not supported for
PIM-DM.
• Designated Router — The designated router on the selected PIM interface. For point-to-point
interfaces, this is 0.0.0.0.
Interface Neighbors fields are:
• Neighbor Count — The number of PIM neighbors on the selected interface.
•
Neighbor IP — The IP address of the PIM neighbor for which this entry contains information.
• Up Time (hh:mm:ss) — The time since this PIM neighbor (last) became a neighbor of the local router.
Expiry Time (hh:mm:ss) — The minimum time remaining before this PIM neighbor is aged out.
Displaying PIM-DM Interface Summary using the CLI Command
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• PIM-DM Commands