Dell PowerConnect M6220 User Manual
Page 273
Configuring Switching Information
271
• Action — Selects the ACL forwarding action. Choose from the drop-down menu options to apply a
forwarding action. Possible values are:
–
Permit — Forwards packets which meet the ACL criteria.
–
Deny — Drops packets which meet the ACL criteria.
•
Assign Queue ID — Click the check box to apply this criteria, then enter an identifying number from
0 to 6.
• Redirect Interface — Select from the drop-down list of interfaces one that packets meeting this rule
can be redirected to.
•
Mirror Interface — Select from the drop-down list of interfaces one that packets meeting this rule can
be mirrored to.
• Logging — Enables logging for a particular ACL when the check box is selected. Logging is supported
for Deny action only.
•
Match Every — Requires a packet to match the criteria of this ACL. Click the check box to apply this
criteria. Match Every is exclusive to the other filtering rules, so if checked, the other rules on the screen
aren’t accessible.
•
Protocol — Requires a packet’s protocol to match the protocol listed here. Click the check box to
apply this criteria, then select one of the following:
–
Select from List — Select from the drop-down list of protocols on which the rule can be based.
–
Match to Value — Click to add a user-defined Protocol ID used to match packets to the rule.
•
Source IP Address — Requires a packet’s source port IP address to match the address listed here. Click
the check box and enter an address to apply this criteria.
• Wild Card Mask — Specifies the source IP address wildcard mask. Wild card masks determines which
bits are used and which bits are ignored. A wild card mask of 255.255.255.255 indicates that no bit is
important. A wildcard of 0.0.0.0 indicates that all of the bits are important. This field is required when
Source IP Address is checked.
•
Source L4 Port — Requires a packet’s TCP/UDP source port to match the port listed here. Click the
check box to apply this criteria, then select one of the following from the drop-down menu:
–
Select From List — Click to select from a list of source ports on which the rule can be based.
–
Match to Port — Click to add a user-defined Port ID by which packets are matched to the rule.
•
Destination IP Address — Requires a packet’s destination port IP address to match the address listed
here. Click the check box and enter an address to apply this criteria.
•
Wild Card Mask — Specifies the Destination IP address wildcard mask. This field is required when
Destination IP Address is checked.
• Destination L4 Port — Requires a packet’s TCP/UDP destination port to match the port listed here.
Click the check box to apply this criteria, then select one of the following:
–
Select From List — Select from a list of destination ports on which the rule can be based.
–
Match to Port — Click to add a user-defined Port ID by which packets are matched to the rule.