Dell PowerConnect M6220 - Manual (Page 658)

656 Configuring IP Multicast
Configuring a Multicast Interface using the CLI Command
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• Multicast Commands
Multicast Mroute Summary
Use the Multicast Mroute Summary page to display MRoute data.
To display the page, click IP Multicast > Multicast > MRoute Summary in the tree view.
Figure 12-3. Multicast Mroute Summary
The Multicast Mroute Summary page displays the following fields:
• Source IP — The IP address of the multicast packet source that, combined with the Group IP,
identifies an Mroute table entry.
• Group IP — The destination group IP address.
• Incoming Interface — The incoming interface on which multicast packets for this source/group arrive.
•
Outgoing Interfaces — The list of outgoing interfaces on which multicast packets for this
source/group are forwarded.
• Up Time (secs) — The time in seconds since the entry was created.