Dell PowerConnect M6220 - Manual (Page 665)

Configuring IP Multicast 663
Multicast Route Table
Use the Multicast Route Table page is used to display MRoute data.
To display the page, click IPv4 Multicast > Multicast > Multicast Route Table or IPv6 Multicast >
Multicast > Multicast Route Table.
Figure 12-8. Multicast Route Table
The Multicast Route Table page contains the following fields:
• Group IP — The destination group IP address.
• Source IP — The IP address of the multicast packet source that, combined with the Group IP,
identifies an multicast route table entry.
• Incoming Interface — The incoming interface on which multicast packets for this source/group arrive.
• Outgoing Interfaces — The list of outgoing interfaces on which multicast packets for this
source/group are forwarded.
• Up Time — The time in hours:minutes:seconds since the entry was created.
• Expiry Time — The time in hours:minutes:seconds before this entry ages out and is removed from the
table.
• RPF Neighbor — The IP address of the Reverse Path Forwarding neighbor.
• ProtocolFlags — The multicast routing protocol which created this entry. The possibilities are:
– PIM-DM
– PIM-SM
– DVMRP
• Flags — The value displayed in this field is valid if the multicast routing protocol running is PIM-SM.
The possible values are RPT or SPT. For other protocols a “------” (no value) is displayed.