HITEC Flash 7 - Manual (Page 74)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
73
Butterfly Mixing (GLID Only) cont.
To configure butterfly:
1. From the model menu, rotate the jog dial to highlight “B-Fly”
and press the jog dial once to enter the activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select “ACT” (activate), then press the jog
dial to confirm your selection and activate the butterfly menu.
4. Scroll to highlight the “AILE” field and press the jog dial to
activate the menu.
5. Rotate the jog dial to input the desired travel for the “AILE”
servo when Butterfly is active. Press the jog dial to confirm
your input.
6. If the model has a second aileron servo, repeat step 5 in the
“AIL2” field.
7. Scroll to highlight the “ELEV” field and press the jog dial to
activate the menu.
8. Rotate the jog dial to input the desired travel for the “ELEV”
servo when Butterfly is active. Press the jog dial to confirm
your input.
9. If the model has a second elevator servo, repeat step 8 in the
“ELE2” field.
10. Scroll to highlight the “FLAP” field and press the jog dial to
activate the menu.
11. Rotate the jog dial to input the desired travel for the “FLAP”
servo when Butterfly is active. Press the jog dial to confirm
your input.
12. If the model has a second flap servo, repeat step 11 in the
“FLP2” field.
13. Press the back button to return to the butterfly menu.
14. Scroll to highlight the “SPEED” field and press the jog dial to
activate the menu.
15. Scroll to define the amount of time (0.0 to 10.0 seconds) for
the butterfly mix to fully deploy. Press the jog dial to confirm
your selection.