HITEC Flash 7 - Manual (Page 25)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 2: Quick Start Guides
24
The following information is designed to guide you through a simple setup of a standard sport plane or
unpowered glider. The operations shown during this exercise will help you understand many of the basic
programming steps used by the Flash 7.
Channel Assignments for a Simple Powered Plane with One or Two Aileron Servos:
Channel 1 - Aileron
Channel 2 - Elevator
Channel 3 - Throttle
Channel 4 - Rudder
Channel 5 - Aileron #2 (if used)
Channel Assignments for a Simple Un-Powered Glider:
Channel 1 - Aileron (plug rudder or aileron servo in Ch. #1)
Channel 2 – Elevator
This exercise assumes two things:
1. That you have already installed the servos in your aircraft.
2. That you bound (linked) the receiver to your transmitter.
Airplane Quick Start Guide
1. Turn on the transmitter. Do not turn on the airplane.
2. When prompted if you are “Ready to Transmit” select “No”.
3. Press the jog dial and back button simultaneously to enter the
System Menu list.
4. From the System Menu list choose MDL.SEL to enter the
model setup.
5. Select the first default model (NONAME-1) and press the jog
dial to bring up the model maintenance prompts. Select
“NEW” to create a new model.
For safety reasons during this set-up exercise on an electric powered plane, remove the
propeller.
Warning
Note
Tip Tip
Tip Caution
If you are setting up a powered or un-powered glider, we will be programming your plane into
the ACRO menu for this exercise. Later you can explore the functions found in the GLID menus.
Note
Tip Tip
Tip