HITEC Flash 7 - Manual (Page 72)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
71
Flap Control
7. Scroll to highlight the “R/D” (right/down) field and press the
jog dial to activate the menu.
8. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint for when
the flap is fully deployed.
9. If the model has a second flap servo, repeat steps 4-8 on the
“FLP2” row of the value table.
10. Press the back button to return to the flap control menu.
11. Scroll to highlight the “ELEV” field and press the jog dial to
activate the menu.
Be sure to have the elevator servo(s) configured properly before performing the next step.
Note
Tip Tip
Tip Caution
12. Rotate the jog dial to input the desired amount of elevator throw when the flaps are fully deployed.
Press the jog dial to confirm your input. Most models require down elevator with flap deployment,
which equates to positive values in this menu.
13. Scroll to highlight the “SPEED” field and press the jog dial to
activate the menu.
14. Scroll to define the amount of time (0.0 to 10.0 seconds) for
the flaps and elevator mix to fully deploy. Press the jog dial
to confirm your selection.
15. Press the back button to return to the model function menu.
To disable flap control:
1. Scroll to highlight the “MIX” field in the flap control menu and
press the jog dial to activate the menu. 2. Select “INH” (inhibit)
and press the jog dial to confirm your selection. Goes with
above screen shot.
3. Press the back button to return to the model function menu.
Offset
The Offset feature provides a convenient method to fine tune the neutral positions of the aileron, flap,
and elevator servo.
To configure offset:
1. From the model menu, rotate the jog dial to highlight “Offset”
and press the jog dial once to enter the activation menu.