HITEC Flash 7 - Manual (Page 50)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 4: Common Model Programming Menu
49
Programmable Mixes cont.
channel along with a P-mix.
1. From the model menu, scroll to highlight “PROG.MIX” and
press the jog dial once to enter the programmable mix menu.
2. Scroll to highlight the mix to be configured and press the jog
dial to activate the selection.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to confirm your selection and activate the sub-menu for
the selected mix.
4. Scroll to select the master/slave field and press the jog dial to
activate the menu.
5. Scroll to select the master function field (left field) and press
the jog dial to activate the menu.
6. Scroll to select the desired function to be the master function
for the mix (THRO, RUDD, GEAR. etc.) and press the jog dial to
confirm your selection.
7. Scroll to select the slave function field (right field) and press
the jog dial to activate the menu.
8. Scroll to select the desired function to be the slave function
for the mix and press the jog dial to confirm your selection.
Press the back button to return to the programmable mix sub-
menu.
9. Scroll to highlight the “RATE” field and press the jog dial to
activate the menu.
Example: Let’s say you want to control your ailerons as flaps using one of the slider switches but you
don’t want to have the slider active all the time in case you accidentally bump it. You can assign the slider
to your virtual channel and then P-mix that channel to the aileron servos. Since you have the option to
have the P-mix activated with a switch, the slider will only be active when the switch is in the on position.
While this is just one example, there are many other uses. If you run into a situation where you cannot get
the results you are looking for through normal mixing, consider using the virtual