HITEC Flash 7 - Manual (Page 71)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
70
Camber Mixing (GLID Only) cont.
- Repeat steps 4-18 to define the settings for each flight condition.
17. Press the back button to return to the model function menu.
To configure flap control:
1. From the model menu, rotate the jog dial to highlight “FLAP
CON” and press the jog dial once to enter the activation menu.
You may also select a flight condition in this menu by activating the desired flight condition.
Note
Tip Tip
Tip Caution
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select “ACT” (activate), then press the jog
dial to confirm your selection and activate the flap control
menu.
4. Highlight the “FLAP” row of the value table and press the jog
dial to activate the menu.
To disable the elevator-to-camber mix:
1. Scroll to highlight the “MIX” field in the camber mix menu and
press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to confirm your
selection.
3. Press the back button to return to the model function menu.
Flap Control
Flap Control is used to mix elevator control with flap movements. This is an effective way of avoiding pitch
changes to the aircraft when flaps are deployed.
5. Scroll to highlight the “L/U” (left/up) field and press the jog
dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the assigned flap channel. This value defines the
end point when the flap is fully retracted. Set this value
carefully to avoid any binding of the control linkages. Press the
jog dial to confirm your input.