HITEC Flash 7 - Manual (Page 65)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
64
Aileron to Rudder Mixing cont.
7. Scroll to highlight the “R/D” (right/down) field and press the
jog dial to activate the menu.
8. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired rudder travel when a right roll
command is given. Press the jog dial to confirm your input.
9. Scroll to highlight the “EXP” field and press the jog dial to
activate the selection.
10. Rotate the jog dial to input the desired exponential travel of
the rudder when reacting to this mix. The setting does not
affect exponential travel when yaw commands are given.
11. Scroll to highlight the “TRIM” field and press the jog dial to
activate the menu.
12. Scroll to select “ON” or “OFF” and press the jog dial to confirm
your selection. When “ON” is selected, the mix reacts to trim
adjustments of the ailerons. Otherwise, the mix ignores
aileron trim changes.
13. Scroll to the “S/W” field and press the jog dial twice to
activate the menu.
14. Scroll to select a switch to activate the mix. Press the jog dial to confirm your selection.
a. If you choose the “NULL” option, the mix will remain active at all times for this model.
b. If you choose a switch:
- The switch position menu will appear. Scroll to highlight the
switch position that you will use to enable the mix. Press the
jog dial to confirm your selection.
- Scroll to select “ON” and press the jog dial to confirm your
selection. If you toggle the selected switch, the field in the
top right corner of the screen will indicate when the mix is
active.