HITEC Flash 7 - Manual (Page 70)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
69
Camber Mixing (GLID Only) cont.
10. Scroll to highlight the “FLAP” field and press the jog dial to
activate the menu.
11. Rotate the jog dial to input the desired travel for the “FLAP”
servo when camber is active. Press the jog dial to confirm
your input.
12. If the model has a second flap servo, repeat step 11 in the
“FLP2” field.
15. Scroll to the “S/W” field and press the jog dial twice to
activate the menu.
13. Scroll to highlight the “SPEED” field and press the jog dial to
activate the menu.
14. Scroll to define the amount of time (0.0 to 10.0 seconds) for
the camber settings to fully deploy. Press the jog dial to
confirm your selection.
b. If you choose a switch:
- The switch position menu will appear. Scroll to highlight
the switch position that you will use to enable the mix.
Press the jog dial to confirm your selection.
16. Scroll to select a switch to activate the camber mix. Press the jog dial to confirm your selection.
a. If you choose the “NULL” option, the mix will remain inactive at all times for this model.
- Scroll to select “ON” and press the jog dial to confirm your
selection. If you toggle the selected switch, the field in the
top right corner of the screen will indicate when the mix
is active.
c. If you choose “Cond” (Flight Condition):
- The upper right field of the menu displays which flight
condition is currently active and will be programmed.
- Scroll to the Flight Condition field and press the jog dial to
activate the menu.
- Choose the desired flight condition and press the jog dial
to confirm your selection.