HITEC Flash 7 - Manual (Page 39)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 3: System Menu Programming
38
Trainer Function cont.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select “ACT” (activate), then press the jog
dial to confirm your selection and activate the trainer menu.
6. Within the trainer menu, you can choose to limit the control
the student has for each channel by selecting one of the three
choices:
- NOR for full control.
- MIX for limited control.
- OFF for no Control.
4. Scroll to highlight “MODE” and press the jog dial to activate
the menu.
7. To adjust the level of control for any channel, scroll to the
channel you want to change and press the jog dial to activate
the selections.
8. Scroll to select “NOR”, “MIX”, or “OFF” and press the jog dial to
confirm your selection.
Within the trainer function menu you can choose to limit the control the student has by
selecting one of the three choices; NOR for full control, MIX for limited control or OFF for no Control.
Note
Tip Tip
Tip
Section 3: System Menu Programming
Within the trainer menu, you can set the Flash 7 as a “Master radio”, set the trainer switch, and activate the
other features. To do this, the transmitter must be in transmit mode. If not in the transmit mode, the only
options you will have are the “pupil” options.
To configure the trainer function:
1. From the system menu, scroll to highlight “TRAINER” and press
the jog dial once to enter the activation menu.
5. Scroll to select the number of channels the student radio
can control:
ALL – Gives the student access to all control channels 1~7.
STICK – Gives the student access only to the stick (gimbal)
channels 1~4.
Press the jog dial to confirm your selection.