HITEC Flash 7 - Manual (Page 35)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 3: System Menu Programming
34
Model Type GLID Menu Programming cont.
6. Scroll to the Tail selection menu and press the jog dial to activate
the selections and scroll through the choices. The choices for tail
type are dependent on the type of wing you selected.
The tail types you may choose with the basic GLID wing types are:
NORMAL:
Rudder is located on a vertical stabilizer and elevator is on a
horizontal stabilizer.
V-TAIL:
Two control surfaces in a V-configuration operate together providing
both yaw (rudder) and pitch (elevator) control.
Ailevator:
Each half of the elevator is controlled by a dedicated servo to provide
pitch (elevator), and roll (aileron) control.
The tail types you may choose with delta wing types are:
None: For Delta Wing Models without a rudder.
1Servo: For Delta Wing Models with a single rudder servo.
2Servo: For Delta Wing Models with dual rudder servos.
4. Once in the GLID setup menu you will set your wing and tail
choices. Scroll to the wing selection and press the jog dial to
activate the selections and scroll through the choices.
The choices for Normal GLID wing type are:
Additionally there are setups for Delta wing type models (Elevon):
ELEVON
ELEVON+1FLAP
ELEVON+2FLAP
DELTA
5. Once you have selected you wing type, press the jog dial to confirm your selection.
7. Select the tail type that your model has and press the jog dial to confirm your selection.
8. Press the back button to return to the system menu.
1AILE – Single aileron servo
1AILE+1FLAP – Single aileron servo and single flap servo
1AILE+2FLAP - Single aileron servo channel and two flap servos
2AILE – Two aileron servos
2AILE+1FLAP - Two aileron servos and one flap servo
2AIL+2FLAP - Two aileron servos and two flap servos