HITEC Flash 7 - Manual (Page 68)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
67
Elevator to Camber Mixing cont.
18. Scroll to select “FLAP” and press the jog dial to confirm your
selection.
19. Repeat steps 5-15 to configure the flap movements for this
mix. If using only one flap servo, configure only the “FLAP”
row of the value table. If using two flap servos, configure
both rows of the value table.
20. Scroll to the “S/W” field and press the jog dial twice to
activate the menu.
21. Scroll to select a switch to activate the mix. Press the jog dial
to confirm your selection.
a. If you choose the “NULL” option, the mix will remain active at
all times for this model.
b. If you choose a switch:
- The switch position menu will appear. Scroll to highlight the
switch position that you will use to enable the mix. Press the
jog dial to confirm your selection
You may also select a flight condition in this menu by activating the desired flight condition.
Note
Tip Tip
Tip Caution
c. If you choose “Cond” (Flight Condition):
-The upper right field of the menu displays which flight
condition is currently active and will be programmed.
- Scroll to select “ON” and press the jog dial to confirm your
selection. If you toggle the selected switch, the field in the
top right corner of the screen will indicate when the mix is
active.
- Scroll to the Flight Condition field and press the jog dial to
activate the menu.
- Choose the desired flight condition and press the jog dial to
confirm your selection.
- Repeat steps 4-18 to define the settings for each flight condition.