Camber mixing (glid only) – HITEC Flash 7 User Manual

Page 69

7 Channel 2.4 GHz Aircraft Computer Radio System

Section 5: Acro and Glider Programming Menu

Elevator to Camber Mixing cont.

22. Press the back button to return to the model function menu.

To disable the elevator-to-camber mix:
1. Scroll to highlight the “MIX” field in the elevator-camber mix
menu and press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to confirm your
selection.
3. Press the back button to return to the model function menu.

To configure the camber mix:
1. From the Model menu, rotate the jog dial to highlight “Camber
Mix” and press the jog dial once to enter the activation menu.

2. Press the jog dial again to activate the menu.

3. Rotate the jog dial to select “ACT” (activate), then press the
jog dial to confirm your selection and activate the camber mix
menu.
4. Scroll to highlight the “AILE” field and press the jog dial to
activate the menu.

Camber Mixing (GLID Only)

The Camber Mix feature allows you to define the camber of the wing airfoil by raising or lowering the
wing control surfaces in unison. You may also adjust the elevator neutral position in each setting to
maintain proper pitch trim.

5. Rotate the jog dial to input the desired travel for the “AILE”
servo when camber is active. Press the jog dial to confirm
your input.
6. If the model has a second aileron servo, repeat step 5 in the
“AIL2” field.

7. Scroll to highlight the “ELEV” field and press the jog dial to
activate the menu.
8. Rotate the jog dial to input the desired travel for the “ELEV”
servo when camber is active. Press the jog dial to confirm
your input.
9. If the model has a second elevator servo, repeat step 8 in the
“ELE2” field.