Echelon LonPoint Module - Manual (Page 74)

6-2 Installing the DIO-10 Input/Output
Modules
LonPoint DIO-10 Digital Input/Output Modules
The front panel is shown in figure 6.1. There are no user-configured jumper blocks on
the DIO-10 module. A separate front panel LED is provided for each input, and a
Hand/Off/Auto switch and LED are provided for each output.
The four hand/off/auto switches control the outputs of the DIO-10 as long as the module
is powered, regardless of the software state of the module. The four status LEDs will
track the state of the outputs only if the application program is running and the module
is in the configured state. The status LEDs will not fuction if the module is in an uncon-
figured state.
Network Access Jack; Use
With Echelon PCC-10 Cable
Model 78303
Peel-Off Code 39
Format Bar Code of
LonPoint Interface
Neuron Chip ID
Number
LonPoint Interface
Model and Software
Revision
Service LED
Service Switch
Power/Wink LED:
Power ON: Illuminated Continuously
Wink: Flashing
Lo
nP
oi
nt
™
In
te
rfa
ce
1
2
1
2
1 2
DIO-10
MODEL 41500 9820
SW VERSION 3.0
ID NUMBER
INPUT: 0-32VDC
LISTED 178K
ENERGY MANAGEMENT
EQUIPMNT SUBASMBLY
OUTPUT: 30V AC/DC, 2A
DIO-10 MODEL 41500 ID NUMBER
DIO-10 MODEL 41500 ID NUMBER
HAND/OFF/AUTO Switches
(manual) (network)
E
c us m L U
®
Digital Input Status LEDs
Digital Input 1 LED
Digital Input 2 LED
Digital Input 1 LED
Digital Input 2 LED 1
2
1
2
1 2 3 4
Figure 11.1 LonPoint DIO-10 Digital Input/Output Module - Front Panel