Echelon LonPoint Module - Manual (Page 56)

4-20 Installation and Wiring of Base Plates
As shown in figure 4.18, the Type 2 Base Plate is intended to be installed in an electrical
box either vertically (base plate interior arrows pointing up) or rotated clockwise 90°
(base plate interior arrows pointing to the right). These two orientations provide
optimal viewing of the front panel legends of an installed LonPoint module, and also
accommodate different methods of installing electrical boxes.
Figure 4.18 LonPoint Type 2 Base Plate Mounting Orientations
Installing A Compatible Electrical Box
Compatible electrical boxes that will accept a Type 2 Base Plate include a 4” square
by 2” deep electrical enclosure (Raco model No. 232, 236, 7232, 7054 or equal), two-