AMT Datasouth Documax A6300 - Manual (Page 82)

1
.
.
.
30
The time in seconds that the form will be in the tear
position before automatically returning to the print
position
This feature works only with the Manual Tear key.
Printer Displays Values Description
Auto Tear xxx OFF
IDLE
The printer moves the form into the tear position if the
form is at top and no data is being transmitted.
The printer moves the form into the tear position if the
form is at top and no data is being transmitted.
PAGE Moves the form to the tear bar position on every page
break while on line. The form will retract after the
time specified by the "Auto Time ##" feature has
expired.
Auto Time ###s 1
.
.
.
.
30
The time in seconds that the form will be in the tear
position after more data is sent to the printer
This feature works only when the Auto Tear feature is
ON.
HF: Pos crg x.x" 0.0"
0.1"
0.2"
.
.
.
8.5"
Specifies the position of the carriage, when the Heavy
Forms feature is enabled. The maximum value is
dependent on the current value of the Horz Adj
xxx/144" feature.
HF: xxxxxxxxxx
On Feed
> x.x"
0.0"
0.1"
0.2"
.
5.0"
Specifies when the Heavy Forms sequence is initiated.
On a paper feed greater than x.x inches the carriage is
positioned to the location specified by the HF:Pos crg
x.x" feature. The default = .5" which is 3 lines @ 6
LPI.
On page
break
On a form feed (FF) or paper move that crosses a forms
boundary or bottom margin (page break), the carriage
will be positioned to the location specified by the HF:
Pos crg x.x" feature.
Disabled Heavy forms sequence is disabled.
4-11