AMT Datasouth Documax A6300 - Manual (Page 58)

b. Press the Value  key once or twice to increase the form gap (moves the
printhead away from the form) if there is smudging, smearing or paper
handling issues.
5. Once the adjustment has been made using the keypad, the printer will store the
setting in memory only in the selected profile. The printer will continue to use this
gap setting the next time forms are loaded.
6. Run another print sample. Return to step 2 and repeat until print quality is
acceptable.
7. Manually adjust the form thickness setting as follows (temporary adjustment, not
stored in memory):
a. Turn knob clockwise one click until print quality is acceptable.
b. If smudging occurs, thickness gap is too small. Turn knob one click
counterclockwise until print quality is acceptable.
3-17
CAUTION
MOVING THE PRINTHEAD TOO
CLOSE TO THE FORM CAN RESULT
IN PAPER FEED ING PROBLEMS.
NOTE
There is no direct correlation between
form thickness position and number of
parts in a multi-part form (e.g.
adjustment control is not set to the fourth
mark for a four-part form). Multi-part
carbonless forms must be given time to
cure before being separated to prevent
light print quality. (Contact paper
supplier for cure times.)