AMT Datasouth Documax A6300 - Manual (Page 77)

Feature settings in a profile may be changed through the keypad by following the steps
below.
1. Press the On/Off Line key to take the printer off line.
2. Press the Park key to park paper.
3. Press the Profile key to select profile being changed.
4. Open the Keypad Door.
Figure 4-2. Changing Features In A Profile
5. Press the Next Menu key, as necessary, to scroll through the feature menus until
you reach the menu containing the feature you wish to change.
6. Press the Feature  or Feature  key to scroll the display up or down until you
reach the feature to be changed.
7. Press the Value  key or Value  key to scroll the display backward or forward
until you reach the value you wish to set.
8. Press the Enter key to record the new value.
9. Repeat steps 5 through 8 as necessary until all features are correctly set for your
application.
4-7
10. Close the Keypad Door to exit Setup Mode. The alternating display will read: