AMT Datasouth Documax A6300 - Manual (Page 65)

The printer may be configured to automatically change paper paths during a paper out
condition. The Path feature must be set to “Either” for this to occur.
After changing paths, the printer will attempt to load. If paper is found, printing will
continue. If no paper is installed, the unit will stop and indicate a paper out condition.
To enable this feature:
1. Open Keypad Door.
2. Press the Next Menu key until Menu 4 is displayed.
3. Press Feature  until the feature is displayed.
4. Press Value  or  to select ‘On’, and then press the Enter key to save selection.
5. Close Keypad Door and press the Profile key to save profile.
3-24
3.13 Selecting Paper Paths Using The Profile Key
NOTE
This may be useful in applications where
the printer is unattended or installed at a
remote location. If this feature is
enabled, the same forms must be loaded
in both paper paths.
M4 PRINTER CNTRL
Auto Path SW Off