AMT Datasouth Documax A6300 - Manual (Page 16)


17.0 inches (431 mm)wide x 15.7 inches (398 mm) deep x 11.3 inches (287 mm)
high (Standard model).

17.0 inches (431 mm) wide x 16.7 inches (424 mm) deep x 12.3 inches (312 mm)
high (Cut Sheet model).
Location
1. To permit air flow and proper cooling, do not place anything closer than 2 inches
(50mm) to the printer.
2. Allow 6 inches to the right of the printer for access to the Form Thickness
Adjustment knob.
3. For continuous printing and accumulation of forms, allow sufficient room behind
the printer for cables and stacking forms.
4. Place the printer on a sturdy level surface and align lower front edge of printer
with table edge. The feet should be at least one inch from the edge of the table.
5. Locate the printer near a grounded power receptacle and use the power cord
provided. Do not use an extension cord to connect the printer.
6. Avoid the following:

Direct sunlight or excessively illuminated areas

Direct placement in front of air conditioning or heating vents

Extreme high or low temperatures

Exposure to excessive dirt or dust

Exposure to vibration or mechanical shock

Excessive humidity or condensation
1-5
1.5 Printer Parts
Four basic models of the printer are available.

Standard straight tractor paper path with standard access cover.

Straight tractor paper path with top roller set and sound reduction access cover.