AMT Datasouth Documax A6300 User Manual
Page 48
Figure 3-6. Press Load Key
10. For Cut Sheet forms, set left paper guide window at the "0" mark. Grab form in
center with one hand and align left edge of form against left paper guide. (Do not
fully insert form.)
Use other hand to snug right paper guide against right edge of form. (Do not
buckle forms between paper guides.)
Push in form until leading edge is squarely against rollers. (Care should be taken
to keep form straight.) Printer will automatically load form and go on line.
NOTE
To eject a cut sheet form for any reason,
press the Form Feed key.
NOTE
If cut sheet form length is between 4.5"
and 6.0", verify that the Vertical Gap
Position Feature is set to 0.0" (located
under M8 FORM THICKNESS in the
setup mode). See Section 4.6 for further
instructions on how to change this setting.
Failure to set vertical Gap for these forms
may cause trailing edge of form to catch
under guide during loading