AMT Datasouth Documax A6300 - Manual (Page 78)

To answer "Yes", press the Profile key. This will permanently record the change
in non-volatile memory for that profile.
To answer "No", press any other key. This will make the change temporary, thus
not changing the original profile setting. These settings will be valid until profiles
are changed again or the printer is powered off.
11. Press Load key to load paper (resets top of form).
12. Press the On/Off Line key to return to operation .changed again or the printer is
powered off.
As an example, assume the profile you are presently using defines the lines per inch as 6.
To permanently change the lines per inch to 8, proceed as follows:
1. Press the On/Off Line key to take the printer off line.
2. Press Park key to park paper.
3. Open the Keypad Door to enter Setup Mode.
4. Press the Feature  key to select Lines/Inch.
5. Press the Value  key to change the Lines/Inch to 8 lines.
6. Press the Enter key to save the new Lines/Inch value.
4-8
7. Close the Keypad Door to exit Setup Mode. The LCD will read:
Press the Profile key to save entry.
NOTE
To maintain correct top of form
alignment when a profile change is made,
the paper should be parked (if not
already parked) and reloaded so that the
printer can reset the top of form for the
new profile.
Press `Profile'
Press ‘Profile’
To Save Settings