AMT Datasouth Documax A6300 - Manual (Page 53)

3.5 Top Of Form Adjustment
(Adjusting First Printline Location)
When paper is loaded into the printer, the printer automatically positions the paper to print
on the first line of the form. If you need to change the location of the first print line use
the Adjust Form key, and proceed as follows:
1. To place the printer in Top of Form Adjust Mode, open the Keypad Door and
press the Adjust Form key. The form will advance until the bottom of the first
print line is positioned just above the tear off bar for viewing (see Figure 3-9).
(For units equipped with cut sheet option, open the top access cover and use the
metal tear edge just above the top rollers).
If at top of form the LCD will alternate:
If not at top of form the LCD will alternate:
2. Use the Value  and Value  keys to move the paper up or down to the position
desired for next line of print. The line directly above the tear bar will be the next
print line (Figure 3-9).
3. Press the Adjust Form key or close Keypad Door. The printer will reverse feed
the form back to print position.
4. This adjustment affects the Load feature and is automatically saved in memory for
the current profile and will apply the next time forms are loaded.
3-12
NOTE
Perform this adjustment immediately
after loading paper to determine where
the first line will print. Making this
adjustment while printing on the page
allows fine alignment without resetting
line count.
Adj. First Line
Use Value Keys
Fine Adjustment
Use Value Keys