AMT Datasouth Documax A6300 - Manual (Page 138)

Cut Sheet
Comp 0-24 Adjusts the vertical feed rate for cut sheet forms
This feature is used when exceptionally thick, stiff and long
forms are not printing at exactly 6 lines/inch or 8 lines/inch.
Increasing this value compresses the vertical spacing.
Decreasing this value expands the vertical spacing.
This is factory set to the correct value and rarely needs to be
adjusted.
Cut Sheet
Time Off
1 - 300
Disabled
Automatically switches from cut sheet path to tractor path after
"x" (1-300) seconds.
This feature saves time by reloading tractor forms and going "On
Line" after last cut sheet form is printed.
The Path feature (located under M2 Forms Control) must be set
to Either to enable this feature.
Ribbon Life xx M 1...50 This feature indicates the ribbon cartridge life in millions of
character.
When the Ribbon xx% Usage feature reaches 100%, the printer
displays:
< Ribbon Life End >
The ribbon must be replaced.
This feature value should not be changed unless otherwise
specified on the ribbon cartridge box.
The feature defaults to 10 M characters which is based on the DP
font. The number of characters printed per ribbon will vary
based on actual application. The printer stores this value in
dots per ribbon to ensure percent usage is correct for any font
or print mode including barcodes.
Replace Ribn xx% 0...100 This feature sets the % usage limit at which the printer displays:
< Replace Ribbon >
Ribbon xx% Used
This indicates the ribbon is near its end of life and should be
replaced.
This message replaces the normal on line/off line display.
Check Ribbon xx% 0...100 This feature sets the % limit at which the printer displays:
< Check Ribbon >
Ribbon xx% Used
The printed media should be checked for acceptable print
contrast. This message will disappear from the display
whenever the printer is taken off line. It will then only be
displayed on power up.
D-2