AMT Datasouth Documax A6300 - Manual (Page 129)

B.4 Serial Interface Selection
1. Set the power switch to On.
2. Press the On/Off Line key.
3. Open the Keypad Door. The first menu will appear on the display.
4. Press the Next Menu key until you have accessed Menu 5. The display will appear
as shown.
5. Press the Feature  keys to select the Serial feature.
6. Press the Value  key to select RS-232, RS-422, or disable.
7. Press the Enter key to accept your selection.
There are five additional features which allow you to configure the serial interface to
suit your needs: Parity, Data Bits, DTR, Handshake and Modem Control. All five
features are contained in Menu 5, Serial Control. Each feature is explained in detail in
Chapter 4. After you finish your serial interface configuration, continue with step 8.
8. Close the Keypad Door to exit Setup Mode. The messages will alternate on the
display as shown.
9. Press the Profile key to save profile.
10. Press the On/Off Line key to place the printer back on line.
B-9
RS-232 Serial Interface Connector Pin Assignment
PIN SIGNAL NAME
M5 SERIAL CNTRL
Press `Profile'
To Save Settings