AMT Datasouth Documax A6300 - Manual (Page 50)

3.4 Format Page
Set Form Length
To determine form length, first measure the length of the form (in inches) and multiply this
value by the vertical lines per inch.
For example, if the form length is 11 inches and the vertical pitch is 6 lines per inch, then
the form length would be:
11 inches x 6 lines per inch = form length 66 lines
To set the form length, open the keypad door and press the Quick Access key until "Form
Length" appears in the display. Press the Value keys to change the setting and press the
Enter key to save the setting.
Set Left and Right Margins
To determine left and right margins, measure the printed width of the form (in inches
excluding pinfeed holes) and multiply this value by the font pitch. The scale on the tear
off bar may be used to estimate margin location for 10 cpi. (see figure 3-8).
For example, if the printable form width is 6.5 inches and the font pitch is 10 characters
per inch, then the form width would be:
6.5 inches x 10 cpi = right margin 65
3-9