27 feature 66 - parallel interface disable, 28 feature 69 - downloadable character enable, 29 feature 70 - bar code enable – AMT Datasouth 41AY89AR777 User Manual
Page 48: 30 feature 76 - micro mode, 31 feature 96 - high speed double strike print, 32 feature 97 - bell override
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2.5.27
Feature 66 - PARALLEL INTERFACE DISABLE
When set to 1, Feature 66 causes the printer to ignore any data sent to it over the
parallel interface. If both the parallel interface and serial interface are connected
this feature may be set to prevent the possibility of erroneous characters entering
the FIFO buffer.
2.5.28
Feature 69 - DOWNLOADABLE CHARACTER ENABLE
When Feature 69 is set to 1, the printer will print any user defined characters that
have been downloaded to the printer. When Feature 69 is set to 0, the printer will
print standard ROM based characters.
2.5.29
Feature 70 - BAR CODE ENABLE
Feature 70 is set to 1 to enable bar code printing capabilities. Setting Feature 70
to 0 will disable bar code capabilities. Feature 70 must be set to 0 for normal
printing operations.
2.5.30
Feature 76 - MICRO MODE
When Feature 76 is set to 1, all printed characters will be vertically condensed.
All fonts may be printed in micro mode.
2.5.31
Feature 96 - HIGH SPEED DOUBLE STRIKE PRINT
Feature 96 enables high speed double strike mode. When in this mode, the printer
will strike each character twice in order to improve the print quality when using
multipart forms. Each line of print is printed in one pass at 3/4 print speed. High
speed double strike is enabled when Feature 96 is set to 1. This feature acts only
on draft and memo fonts.
2.5.32
Feature 97 - BELL OVERRIDE
The operator may set Feature 97 to override the printer bell so it does not sound.
When Feature 97 is set to 0, the bell will sound. "When Feature 97 is set to 1, the
bell will not sound.
2-21