AMT Datasouth 41AY89AR777 User Manual
Page 123
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

5.4.3 PAPER FEED PROBLEMS
Printer occasionally misses a line feed, causing a printover.
Cause
Solution
Restricted paper path.
Clear ttie paper path. Paper should not travel across
desk comer, edge of paper box, etc. Ensure that
paper has direct path into printer.
Paper won’t advance.
Cause
Solution
Form feed features
2, 3,11 and 38 are not
set properly.
Verify the correct setting of Features 2, 3,11 and
38. For information on how to set these features,
see Chapter 2.
Paper feeds through printer continuously.
Cause
Solution
incorrect baud rate for
Verify the correct baud rate setting in Feature 1 and
serial connection.
from the host
Large number of
Press Reset key to clear the memory in the buffer
form feeds sent to
and stop the paper.
printer.
Check the host computer software.
Paper tearing on right or left side.
Cause
Solution
Forms tractors are too
close or too far apart.
Adjust tractors to fit form being used. See Section 1
for proper tractor setting.
Margin setting causes
printhead to move
beyond paper edge.
Reset the right margin using Feature 6. or reset the
left margin using Feature 5.
Move form slightly to the left so edge of printhead
does not leave the paper.
5-12