AMT Datasouth 41AY89AR777 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

2.4.2 Feature 02 - FORM LENGTH
The fonn length on the printer may be programmed for lengths of 1 through 217
lines.
NOTE
If changing Feature 11 (vertical pitch)
or Feature 39 (% lines per inch)
they must be set
before
changing Feature 2 (form length).
Example with form length set to 66 lines:
1.
Enter setup mode as described in Paragraph 2.4 and advance the display to
“02” (the feature number for the form length feature).
2.
Press the Feature Value key and then advance the display to “66” (the desired
value for form length).
3.
Press the Set key to enter the value in the non-volatile memory.
4.
Press the Exit Semp key to exit setup mode.
Changing form length clears top and bottom margins and sets the top of form at
the current line. Form length of 66 lines is the default value for this feature.
2.4.3
Feature 03 AND 04 - TOP AND BOTTOM FORM
MARGINS, (PERFORATION SKIPOVER)
The feature number for the top margin (first line of print) is 03. The feature
number for the bottom margin (last line of print) is 04. When the printer reaches
the bottom margin of a page and receives a vertical paper movement command
(such as Line Feed, Form Feed, or Vertical Tab) the paper will automatically
slew to the top margin of the next page.
Example with top margin at line 6 and the bottom margin at line 60:
1.
Enter setup mode as described in Paragraph 2.4 and advance the display to
“03” (the feature number for the top margin).
2.
Press the Feature Value key and then advance the display to “05” (the desired
value for the top margin).
3.
Press the Set key to enter the value in the non-volatile memory.
4.
Press the Feature Number key to return to feature mode.
5.
Advance the display to “04” (the feature number for the bottom margin).
6.
Press the Feature Value key and advance the display to “60” (the desired value
for the bottom margin).
7.
Press the Set key to enter the value in the non-volatile memory.
8.
Press the Exit Setup key to exit setup mode.
2-6