1 procedure, 8 how to verify printer operation – AMT Datasouth 41AY89AR777 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1.8 HOW TO VERIFY PRINTER OPERATION
After setting the printer up and loading the paper, perform a print-test. The
print-test is a preprogrammed routine that verifies proper printer operation.
Although the print-test requires limited use of the op«ator panel, it is not
necessary to fully understand the opantor panel at this time. The operator panel
is discussed in greater detail m the next chapter.
Figure 1.10 illustrates the steps in this procedure.
® SET POWER SWITCH ON BACK
OF PRINTER TO "ON’ POSITION
Figure 1.10 Initiating Print Test
1.8.1
PROCEDURE
Before you begin, make sure the printer is loaded with paper which is 10 inches
wide or wider. Otherwise, reduce the right margin using Feature Number 6 to
match the paper width.
To start the print-test, perform the following steps:
1.
Set the power switch to the ON position.
2.
Press the Off line key.
3.
Press the Enter Setup key.
4.
Press the Display T key until the number 99 is displayed. If the display
advances past 99, use the Display A key to return the display to 99, or
continue to hold the Display ▼ key and the display will “wrap around” to
99 after it reaches 1.
5.
Press the Set key to start flie print-test.
Result:
The printer begins printing the programmed pattern.
1-14