beautypg.com

9 feature 36 - automatic line feed, 10 feature 37 - automatic carriage return, 11 feature 38 - form feed defeat – AMT Datasouth 41AY89AR777 User Manual

Page 44: 12 feature 39 - 6/8 lines per inch, 13 feature 40 - paper out detection override

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

2.5.9 Feature 36 - AUTOMATIC LINE FEED

The printer may be configured to automatically perform a line feed upon receipt
of a carriage return command.

To enable Auto Line Feed, Feature 36 should be set to 1.

2.5.10

Feature 37 - AUTOMATIC CARRIAGE RETURN

The printer may be configured to automatically perform a carriage return upon
receipt of a paper movement command (such as Line Feed, Form Feed, or
Vertical Tab).

To enable Auto Carriage Return, Feature 37 should be set to 1.

2.5.11

Feature 38 - FORM FEED DEFEAT

The printer normally performs a form feed upon receipt of a CONTROL L
command from the communications line. In some cases, the user may wish to
defeat this capability.

To enable the Form Feed Defeat, Feature 38 should be set to 1.

NOTE

The form feed defeat is sensitive only to the

CONTROL L command received from the

communications

line. The Form Feed key on the front panel will still

generate a form feed.

2.5.12

Feature 39 - 6/8 LINES PER INCH

The vertical pitch on the printer may be set at either 6 or 8 lines per inch. To
select a vertical pitch of 8 lines per inch, set Feature 39 to 1. To select a vertical
pitch of 6 lines per inch, set Feature 39 to 0. Other vertical pitches may selected
with Feature 11.

2.5.13

Feature 40 - PAPER OUT DETECTION OVERRIDE

A photo sensor is embedded in the paper guide below the print line. When a
paper-out condition occurs, a stop transmission command will be sent to the
computer via the synchronization protocol currently programmed into the printer.
In addition, the paper-out indicator on the front panel will flash continuously and
an audio alarm will sound three short tones. When the forms have been reloaded
and aligned in the printer, press the Continue key. The paper-out indicator will
cease to flash and printing will resume. Since the content of the buffer is retained
and then printed when operation is resumed, no data is lost during a paper-out
condition. The paper-out detection may be overridden by setting Feature 40 to 1.

2-17

This manual is related to the following products: