4 setting value features, 1 feature 01 - baud rates, Setting value features -5 – AMT Datasouth 41AY89AR777 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2.4 SETTING VALUE FEATURES
The following example shows how to use the operator panel to program the right
margin.
1.
Press the Off line key to take the printer off line.
2.
Press the Biter Setup key to enter the setup mode.
3.
Press the Display A until 6 (the feature we wish to change) shows in the
display.
4.
Press Feature Value to display the current right margin setting.
5.
Use the Display A or Display ▼ keys to select the value required for your
application. For example, Display ▼ from the default value of 132 to 85 for
8.5 inch paper if you are using a 10 CPI font.
6.
Press Set to save the value you have selected.
7.
If you wish to change another feature, press the Feature Number key and
follow steps 3 through 7 for each value feature to be changed.
8.
Press the Exit Setup key to exit Setup mode.
9.
Press On line or the Continue key to resume normal operation.
The above example depicts the appropriate procedure for programming features
1 through 26. A description of all value features and instruction on how to
program each are given below.
NOTE
For future reference, record the setting of each
value feature in Appendix E and F, or print a feature listing
via Feature 98.
NOTE
To view or change any feature, the printer must be off line
and in Setup mode.
2.4.1
Feature 01 - BAUD RATES
Baud rates from 110 baud to 19.2K baud may be selected on the printer. The
baud rate must be programmed from the control panel on the printer. Baud rates
cannot be programmed via the communications line.
2-5