1 general information, 1 general information -1 – AMT Datasouth 41AY89AR777 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1 GENERAL INFORMATION
1.1 IN THIS CHAPTER
This chapter explains how to impack, install, and start the printer. It includes
step-by-step instructions for all procedures from unpacking through complete
installation. This chapter also includes illustrations to familiarize you with the
printer parts and to help you perform the procedmes.
1.2 ABOUT THE PRINTER
The printer occupies a surface area 24.5" x 16". Provide at least two inches of
clearance on all sides of the printer for adequate ventilation. Do not block the
exhaust louvers on the side of the cover.
Fonns can be either front-loaded or bottom-loaded. For front-loading, locate the
printer near the front edge of the table so that forms will have a clear path into
the front feed slot. For bottom-loading, place the printer on a stand or a slotted
worktable.
The printer will accommodate forms ranging in width from 3 through 15 inches.
Forms must be the pin feed type. The printers also accommodate multiple-part
forms with as many as six sheets and with a maximum recommended thickness
of 0.021 inch.
Figure 1.1 represents a typical printer. As you smdy this illustration, compare all
parts identified in the illustration to the printer itself. Being familiar with the
printer parts wiU help you install and operate the printer.
1-1